Uberkote™ Sn Regenerator is a liquid flocculant to precipitate stannic tin, which builds up in the tin plating bath. Packaged in 18,93 L pails and 208 L drums. See TDS and SDS under document section for further details.
$400.00
$350.00
You Save : $50.00
(13%)
Uberkote™ Sn Regenerator is a liquid flocculant to precipitate stannic tin, which builds up in the tin plating bath. It also acts as a clarifier making the plating bath clearer. Excessive amounts of stannic tin (Sn+4) in an acid sulphate tin plating bath may increase the additive consumption of the colloidal solids caused by the organic absorbing surfaces. In addition, excessive stannic tin (Sn+4) may cause roughness in rack plating. The oxidation process is well-understood in the plating industry where stannous tin (Sn+2) converts to stannic tin (Sn+4) while operating tin and tin-lead electroplating baths with the stannous tin exposed to oxygen. It is a natural process that can be controlled but not prevented. The Uberkote™ Sn SO4 process contains stabilizers to retard oxidation but not eliminate it. However, combined with proper filtration, this will greatly diminish the oxidation of the divalent tin. When dealing with stannic tin (Sn+4) in a plating bath, the liquid flocculating agent in our product coagulate the colloidal tin (IV). Here is how it works. Add our product with the specific designed flocculant by introducing the flocculating agent to the plating bath with about 0.25 % concentrate. This agent helps bind and aggregate the colloidal tin (IV) particles. The flocculant causes the colloidal tin (IV) to come together, forming larger particles that can more easily be filtered out. This process is known as coagulation. It takes about 24 hours. After coagulation use 5 to 15 micron filters for filtration to remove the aggregated stannic tin particles. This process restores clarity to the tin plating bath. Undesirable accelerated stannic formation can be prevented by eliminating excessive air agitation and by preventing air in the plating solution as well as adding specific anti-oxidants to the bath with 5 to 15 micron filters maintaining continuous filtration. It has been noted if the stannic bath content increases too fast then it is prudent to ensure the anode current density is below 15 amps/sq.ft. For further information see TDS in the document section.